Vehicles
Sections
268 not categorized PORSCHE 911 REAR AXLESCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 GT3 2007-11 (includes uncategorized and accessory items) 477511201BU
$108.90
Make a selection 901333195001
$16.50
Make a selection 115900944018CS Sports suspension for 924 - 944 - 968 only for 18mm spring strut mounting this sports suspension is for everyday use and increase the dynamic and response. The lowering is adjustable (30-70mm front and 30-60mm rear). By using springs at the rear axle instead of torsion bars you improve extreme the handling of your car. By removing the rear torsion bars is the weight saving approximately 25kg.
$3,132.80
Make a selection 64433227100 Rear axle castellated nut. Sold individually. 2 needed per car.
From $35.09
Make a selection NLA34411 This kit contains all necessary shims, o-rings, spacers, oil seal and instructions for one rear axle. Note: sufficient number of shims are included as well as a correct thickness washer.
From $36.30
Make a selection 19271641 The hls provides additional road clearance for lowered vehicles. When expanded, a range of up to 45 mm of lift is produced, thereby helping sport cars avoid road clearance difficulties such as speed bumps, road construction, etc. Kw hls is available as vehicle specific solution or individual conversion kit depending on the car model. Hls is available in two different versions: hls 2 which is fitted to the front axle and hls 4 which can be attached to the front and rear axle and allows lifting the entire vehicle. The hydraulic cylinder unit is located on the coilover body between spring perch and spring. The advantage of a hydraulic system is that there is no compression (motion) of the extended cylinder unit (r...(choose a part on the right to read more) General Fitment911 GT3 2007-11
$7,060.49
Make a selection 19271224 The hls provides additional road clearance for lowered vehicles. When expanded, a range of up to 45 mm of lift is produced, thereby helping sport cars avoid road clearance difficulties such as speed bumps, road construction, etc. Kw hls is available as vehicle specific solution or individual conversion kit depending on the car model. General Fitment911 GT3 2007-11
$6,492.14
Make a selection 00004320656 Pentosin chf 202 hydraulic fluid formulated for power steering, rear axle steering, level control, hydro-pneumatic suspension and shock absorbers. Never mix with atf fluids. Chf 202 and chf 11s are fully compatible in power steering systems. View/Change Diagram
From $14.82
Make a selection 35271424 Kw variant 3 coilover kit with front & rear hls 4 lift system Porsche 997 GT3 & rs 07+ General Fitment911 GT3 2007-11
$13,371.74
Make a selection PAG1674RST4 Pagid racing compounds are complex formulations with very high content of ceramic materials. The difference to competitors metallic compounds is the superior thermal insulation and the higher heat resistance of ceramic compared to iron. Ceramic has a very low heat conductivity, so less brake disc temperature goes through the pad to the caliper. Pagid have measured up to 140 degrees farenheit difference in temperature compared to competitor pads. General Fitment911 GT3 2007-11
$487.08
Make a selection 35271224 Kw variant 3 coilover kit with front hls 2 lift system Porsche 997 GT3 & rs 07+ General Fitment911 GT3 2007-11
$11,481.74
Make a selection FVD57553100 Air brake duct kit for the rear axle. Easy installation. General Fitment911 GT3 2007-11911 TURBO/GT2 2007-09
From $363.88
Make a selection 99760622500 Known as: clip for antenna rear axle View/Change Diagram
$10.54
Make a selection 99760610100 Known as: antenna 433 mhz / antenna 433 mhz use also: rear axle clip 997.606.225.00 View/Change Diagram
$245.73
Make a selection FVD33394401SET Replace worn-out original spring plate bushings to return your car to its intended ride quality and performance. This is a high-quality OEM 65 shore density bushing set, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. This set is a direct replacement for the rear axle strut bushings from original part # 477 511 201 and 477 511 202 sold as a set. 1 necessary per axle.
$108.90
Make a selection FVD33104381 The tow link is the furthest rear control arm on the rear axle. It is responsible for the toe angle adjustment. The OEM control arm bushings are simply too soft for track events and the teflon monoball racing bushings are too far too hard and noisy for street cars. Our sport bushings are made of a denser rubber (85 shore opposed to OEM 65 shore), which means that they are suitable for street and track use. Equally as important is that they do not produce any noise like the teflon bushings. FVD sport control arm facts: - better handling and more responsive. - makes precision adjustments of the suspension easier. - does not produce noise. - shore a hardness value of 85 for durability and handling. - fit's like o...(choose a part on the right to read more)
$482.89
Make a selection BBI9974010001 Features
$1,895.00
Make a selection FVD33105900 Replace worn-out rear trailing arm bushings with our FVD sport bushings, made of rubber with an 85 shore hardness value that is the same as the rs models. 85 shore is more durable, provides more positive suspension location and is still quiet and comfortable for street use. This is a direct replacement for original part # 90133105900 features: better handling makes precision adjustments of the suspension easier does not produce any noise like the teflon bushings. Rubber has a shore hardness value of 85 (like rs models) fit's like oem, simple installation made in Germany set is sold per axle. 1 necessary per car.
$154.00
Make a selection BBI9865010001 Features
$845.00
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |